Tag Archives: Mods

CAD, Design, Electronics, Guitar

Prototype Boost Built, Testing to Come

Building on my work from a couple weeks ago, I put solder to iron and built up a first prototype of the boost circuit for my buddy’s 8-bit fuzz pedal. Th EagleCAD board layout I made earlier was almost exactly what I needed. However, because I was fumbling my way through the software I didn’t have the correct packages selected for all of the devices.

I tweaked the layout with the actual components I ordered from Digikey a few weeks ago. The biggest curveball was that I ordered some gigantic orange 1000pF caps. I just wasn’t looking that closely at packages when I ordered, but I had plenty of board to work with.

I hooked up some 1/4″ jacks to the I/O terminals and connected a 9V. I tested with my Epiphone Les Paul into a Focusrite Scarlet interface. The signal came through clear and clean, and there was no audible (to me at least) distortion as I rolled through the gain range. 

Test-Setup
Board-Left
Board-Right

1 2 3
I’ll take the board over to check out the performance characteristics on an oscilloscope soon. Then, I’ll start looking to shrink the footprint of the board as much as possible so I can cram it inside an existing pedal.

CAD, Design, Electronics, Guitar

Planning and Prototyping a Mosfet Boost Circuit

Long ago I promised my friend Nick a mod for a guitar pedal of his. His 8-bit fuzz pedal caused a volume drop that he couldn’t overcome by tweaking the settings, and he didn’t want to put a boost after because he would have to hit two pedals every time he wanted to switch to his fuzz. I had been looking at making a couple of different boost circuits and offered to put one in his pedal.

Now, some years later, I’m actually putting some effort into the project. The circuit I chose is the Mosfet Booster pedal from AMZ .  The circuit was simple and would make for a very transparent gain stage. The idea is to make a small add-on board for his current pedal and wire the boost in line before the output jack.

I had seen a Hack-a-Day series about creating PCB’s in a number of different software, in particular a walk-through of using Eagle CAD. I’ve seen so many mentions of Eagle CAD over the years, but never used it. This simple circuit would make a good intro to the program.

Continue reading Planning and Prototyping a Mosfet Boost Circuit →

Electronics, Guitar

Pignose G40V Backlog

A few years ago my best friend Nick asked me to do some mods to his amp. He’d recently acquired this cool little brown 40w 10 inch Pignose g40v. The design was very simple and followed an old Bassman schematic pretty closely. The mods that Nick had been eyeing would bring it even closer to the Bassman. He linked me to a couple of blog posts and schematics and I made my way to HSC, a local electronic component warehouse.

The original amp has been holding up well since and has survived him gigging around Utah. When he found another on on Craigslist he made sure to scoop it up and drop it off with me for an upgrade. The second overhaul followed the first very closely, but this time I left out the standby switch and I didn’t break the presence pot and replace it with something only kind of close in value.

I took pictures with the intention of doing a full write up, and one day maybe I will, but for now this project is stuck in the backlog. Enjoy the pictures in the meantime.